SNMP Command Set
Configuring SNMP Users, Groups and Communities
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-15
5.2.2.1 show snmp user
Use this command to display information about users. These are people registered to access SNMP
management.
show snmp user [user [remote remote]]
Syntax Description
Command Defaults
• If user is not specified, information about all SNMP users will be displayed.
• If remote is not specified, user information about the local SNMP engine will
be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display information for the SNMP “guest” user:
Table 5-4 shows a detailed explanation of the command output.
user (Optional) Displays information about a specific user.
remote remote (Optional) Displays information about users on a specific
remote SNMP engine.
Matrix>show snmp user guest
--- SNMP user information ---
EngineId: 00:00:00:63:00:00:00:a1:00:00:00:00
Username = Guest
Auth protocol = usmNoAuthProtocol
Privacy protocol = usmNoPrivProtocol
Storage type = nonVolatile
Row status = active
To Next Page
Loading...
Need help?
General