Enterasys 1G58x-09 User Manual

Security Configuration Command Set
Configuring 802.1X Authentication
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-25
Examples
This example shows how to reset the 802.1X port control mode to auto on all ports:
This example shows how to reset reauthentication control to disabled on Fast Ethernet front panel
ports 1-3:
This example shows how to reset the 802.1X quiet period to 60 seconds on Fast Ethernet front panel
ports 1-3:
14.3.2.7 show eapol
Use this command to display EAPOL settings for one or more ports.
show eapol [port-string]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternatives (v3.xx.xx and higher)
• show dot1x (Section 14.3.2.1)
• show dot1x auth-config authcontrolled-portcontrol (Section 14.3.2.4)
Matrix>clear dot1x auth-config authcontrolled-portcontrol
Matrix>clear dot1x auth-config reathenabled fe.0.1-3
Matrix>clear dot1x auth-config quietperiod fe.0.1-3
port-string (Optional) Displays EAPOL status for specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.2.

Enterasys 1G58x-09 Specifications

General

Redundant Power Supply	Optional
VLANs Supported	4094
Power Supply	100-240 VAC, 50-60 Hz
Weight	7.03 kg
Operating Temperature	0° to 40°C (32° to 104°F)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Operating Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Ports	48 x 10/100/1000BASE-T
Jumbo Frame Support	9, 216 bytes