SNMP Command Set
Configuring SNMP Users, Groups and Communities
5-22 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.2.7 show community
Use this command to display SNMPv1 and v3 community names and access policies. In SNMPv1
and v2, community names act as passwords to remote SNMP management. Access is controlled by
enacting either of two levels of security authorization (Read-Only or Read-Write).
show community
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display community names and access policies:
Table 5-6 provides an explanation of the command output. For details on using the
set community command to assign variables, refer to Section 5.2.2.11.
Matrix>show community
Community Name Permissions
------------------ -----------
Public Read-Write
Private Read-Write
Table 5-6 show community Output Details
Output What It Displays...
Community Name Name through which a user will access SNMP management.
Permissions Access policy granted to each community name, either ro
(Read-Only) or rw (Read-Write).
To Next Page
Loading...
Need help?
General