Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-35
Command Mode
Read-Write.
Example
This example shows how to set the maximum hop count to 40:
6.2.1.40 clear spantree maxhops
Use this command to reset the maximum hop count to the default value of 20.
clear spantree maxhops
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the maximum hop count to 20:
Matrix>set spantree maxhops 40
Matrix>clear spantree maxhops
To Next Page
Loading...