IP Configuration Command Set
Reviewing and Saving the Routing Configuration
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-13
12.2.2.3 no ip routing
Use this command to disable IP routing on the device and remove the routing configuration. By
default, IP routing is enabled when interfaces are configured for it as described in Section 12.2.1.
no ip routing
Syntax Description
None.
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Command Defaults
None.
Example
This example shows how to disable IP routing on the device:
Matrix>Router(config)#no ip routing
To Next Page
Loading...
Need help?
General