Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-49
Example
This example shows how to set the MAC algorithm mode to mac-vid-sequential:
11.2.3.16show dns
Use this command to display DNS (Domain Name Service) settings. DNS translates domain names
into IP addresses.
show dns
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display DNS settings. In this case, DNS is enabled, using three servers
and a domain name of “net.com”:
11.2.3.17set dns domain
Use this command to set the DNS domain name.
set dns domain domain-name
Matrix>set mac algorithm mac-vid-sequential
Matrix>show dns
DNS status: configured
DNS domain: net.com
DNS Servers
------------------
131.141.92.38
131.141.92.39
131.141.92.30
To Next Page
Loading...
Need help?
General