Logging and Network Management Command Set
Configuring System Logging
11-2 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2 LOGGING AND NETWORK MANAGEMENT COMMAND SET
11.2.1 Configuring System Logging
Purpose
To display and configure system logging, including Syslog server settings, logging severity levels
for various applications, and Syslog default settings.
Commands
Commands to configure system logging are listed below and described in the associated section as
shown.
• set logging (Section 11.2.1.1)
• show logging all (Section 11.2.1.2)
• show logging console (Section 11.2.1.3)
• set logging console (Section 11.2.1.4)
• show logging server (Section 11.2.1.5)
• set logging server (Section 11.2.1.6)
• clear logging server (Section 11.2.1.7)
• show logging default (Section 11.2.1.8)
• set logging default (Section 11.2.1.9)
• clear logging default (Section 11.2.1.10)
• show logging application (Section 11.2.1.11)
• set logging application (Section 11.2.1.12)
• clear logging application (Section 11.2.1.13)
• show logging audit-trail (Section 11.2.1.14)
• copy audit-trail (Section 11.2.1.15)
To Next Page
Loading...
Need help?
General