Process Overview: Routing Protocol Configuration
Configuring OSPF
13-26 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.2 Configuring OSPF
Purpose
To enable and configure the Open Shortest Path First (OSPF) routing protocol.
OSPF Configuration Task List and Commands
Table 13-2 lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
.
NOTE: Enabling OSPF with the router ospf and network commands are required if
you want to run OSPF on the device. All other tasks are optional.
Table 13-2 OSPF Configuration Task List and Commands
To do this... Use these commands...
Enable OSPF configuration mode,
associate a network and assign a router
ID.
router ospf (Section 13.1.2.1)
network (Section 13.1.2.2)
router id (Section 13.1.2.3)
Configure OSPF Interface Parameters.
• Set the cost of sending a packet on
an OSPF interface.
ip ospf cost (Section 13.1.2.4)
• Set priority to help determine the
OSPF designated router for the
network.
ip ospf priority (Section 13.1.2.5)
• Adjust timers and message
intervals.
timers spf (Section 13.1.2.6)
ip ospf retransmit-interval (Section 13.1.2.7)
ip ospf transmit-delay (Section 13.1.2.8)
ip ospf hello-interval (Section 13.1.2.9)
ip ospf dead-interval (Section 13.1.2.10)
To Next Page
Loading...
Need help?
General