Logging and Network Management Command Set
Monitoring Switch Network Events and Status
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-31
11.2.2.9 show users
Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
Fragments Number of received frames that are not the minimum
number of bytes in length, or received frames that had a bad
or missing Frame Check Sequence (FCS), were less than 64
bytes in length (excluding framing bits, but including FCS
bytes) and had an invalid CRC. It is normal for this value to
increment since fragments are a normal result of collisions
in a half-duplex network.
Jabbers Total number of frames that were greater than 1518 bytes and
had either a bad FCS or a bad CRC.
Octets Total number of octets (bytes) of data, including those in bad
frames, received on this interface.
0 – 64 Octets Total number of frames, including bad frames, received that
were 64 bytes in length (excluding framing bits, but including
FCS bytes).
65 – 127 Octets Total number of frames, including bad frames, received that
were between 65 and 127 bytes in length (excluding framing
bits, but including FCS bytes).
128 – 255 Octets Total number of frames, including bad frames, received that
were between 128 and 255 bytes in length (excluding
framing bits, but including FCS bytes).
256 – 511 Octets Total number of frames, including bad frames, received that
were between 256 and 511 bytes in length (excluding
framing bits, but including FCS bytes).
512 – 1023 Octets Total number of frames, including bad frames, received that
were between 512 and 1023 bytes in length (excluding
framing bits, but including FCS bytes).
1024 – 1518 Octets Total number of frames, including bad frames, received that
were between 1024 and 1518 bytes in length (excluding
framing bits, but including FCS bytes).
Table 11-5 show rmon stats Output Details (Continued)
Output What It Displays...
To Next Page
Loading...
Need help?
General