General Configuration Command Set
Setting Basic Device Properties
3-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2.2 show system
Use this command to display powers supply status, baud rate, timeout and other system information.
show system
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display system information:
Matrix>show system
Power Supply Status
------------------------
PS1 - Non-Operational
PS2 - Operational
System Baud : 9600 System Timeout : 60 minutes.
System Lockout Time : 15 minutes.
System Uptime : 0 days, 1 hours, 15 minutes, 35 seconds
System Name System Location System Contact
------------------------ ------------------------ ------------------------
sysName sysLocation sysContact
Boot Configuration: Boot from Flash
To Next Page
Loading...