General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-78 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.6.10 show port ciscodp neighborinfo
Use this command to display information about neighboring Cisco devices on one or more ports.
show port ciscodp neighborinfo [details] [port-string]
Syntax Description
Command Defaults
• If details is not specified, summary information will be displayed.
• If port-string is not specified, Cisco DP information will be displayed for all
ports.
Command Type
Switch command.
VVID Whether a Voice VLAN ID has been set on this port. Default
of none can changed using the set port ciscodp vvid
command (Section 3.2.6.14).
#Neigh Number of neighboring Cisco devices detected on this port.
PDU-TX Number of Cisco DP PDUs transmitted on this port.
PDU-RX Number of Cisco DP PDUs received on this port.
CosExt Whether or not a Cisco DP Class of Service has been
defined for this port. Default of undefined can be changed
using the set port ciscodp cos-ext command
(Section 3.2.6.13).
TrustExt Whether or not a trusted status has been defined for this port.
Default of undefined can be changed using the set port
ciscodp trust-ext command (Section 3.2.6.12).
details (Optional) Displays detailed information.
port-string (Optional) Displays information about specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.2.
Table 3-8 show port ciscodp info Output Details (Continued)
Output What It Displays...
To Next Page
Loading...