Logging and Network Management Command Set
Configuring System Logging
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-7
11.2.1.3 show logging console
Use this command to display the global logging state and the severity level at which logging
messages will display to the console port.
show logging console
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This command shows how to display console logging settings. In this case, logging is globally
enabled and the severity level is set to 8 so that debugging level messages will be shown on the
console. For an explanation of the command output, refer back to Table 11-1.
Facility Syslog facility that will be encoded in messages sent to this
server. Valid values are: local0 to local7.
Severity Severity level at which the server is logging messages.
Description Text string description of this facility/server.
Port UDP port the client uses to send to the server.
Status Whether or not this Syslog configuration is currently
enabled or disabled.
Matrix>show logging console
Global Logging State: Enabled
Logging console session: debugging(8)
Table 11-1 show logging all Output Details (Continued)
Output What It Displays...
To Next Page
Loading...
Need help?
General