Security Configuration Command Set
Configuring Access Lists
14-96 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Examples
This example shows how to define access list 101 to deny ICMP transmissions from any source and
for any destination:
This example shows how to define access list 102 to deny TCP packets transmitted from IP source
10.1.2.1 with a port number of 42 to any destination:
14.3.7.4 ip access-group
Use this command to apply access restrictions on an interface when operating in router mode.
ip access-group access-list-number {in | out}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the specified access list:
no ip access-group access-list-number {in | out}
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Matrix>Router(config)#access-list 101 deny ICMP any any
Matrix>Router(config)#access-list 102 deny TCP host 10.1.2.1 eq 42 any
ROUTER: This command can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to Section 3.3.3.
access-list-number Specifies the number of the access list to be applied to the
access list. This is a decimal number from 1 to 199.
in Filters inbound packets.
out Filters outbound packets.
To Next Page
Loading...