Enterasys 1G58x-09 - Set Macauthentication Reauthentication

Security Configuration Command Set
Configuring MAC Authentication
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-39
Command Defaults
None.
Example
This example shows how to force the MAC authentication session for address 00-60-97-b5-4c-07
to re-initialize:
14.3.3.8 set macauthentication reauthentication
Use this command to enable or disable reauthentication of all currently authenticated MAC
addresses on one or more ports.
set macauthentication reauthentication {enable | disable} [port-string]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If port-string is not specified, reauthentication will be enabled or disabled on all
MAC authentication ports.
Example
This example shows how to enable MAC reauthentication on Fast Ethernet front panel ports 1
through 5:
Matrix>set macauthentication macinitialize 00-60-97-b5-4c-07
enable | disable Enables or disables MAC reauthentication.
port-string (Optional) Enables or disables MAC reauthentication on
specific port(s). For a detailed description of possible
port-string values, refer to Section 4.1.2.
Matrix>set macauthentication reauthentication enable fe.0.1-5