Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-15
Example
This example shows how to display SID to FID mapping information for FIDs 1 through 8. In this
case, no new mappings have been configured:
6.2.1.10 set spantree mstmap
Use this command to map a filtering database ID (FID) to a SID. Since VLANs are mapped to
FIDs, this essentially maps a Spanning Tree SID to a VLAN ID.
set spantree mstmap fid_num sid
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show spantree mstmap 1 8
FID: SID:
1 0
2 0
3 0
4 0
5 0
6 0
7 0
8 0
fid_num Specifies a FID to assign to the MST. Valid values are 1 -
4094, and must correspond to a VLAN ID created using the
set vlan command as described in Section 7.3.2.1.
sid Specifies a Multiple Spanning Tree ID. Valid values are 1 -
4094, and must correspond to a SID created using the set
msti command as described in Section 6.2.1.7.
To Next Page
Loading...