Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-81
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set an IP address of 10.1.1.3 for detection group 1:
11.2.6.8 set cep detection protocol
Use this command to specify an IP protocol type for H.323 or Siemens convergence end points
detection. If an IP address is not set for a phone detection group as described in Section 11.2.6.7,
this will configure detection on UDP and/or TCP ports using a port range defined with the set cep
detection porthigh | portlow command as described in Section 11.2.6.9.
set cep detection detection-id protocol {tcp | udp | both | none}
detection-id Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in Section 11.2.6.5. Valid values are 1 -
2147483647.
address Sets an IP address for the CEP discovery group.
ipv4 ip-address |
unknown
Specifies an IPv4 address or an address of an unknown IP
protocol type.
mask Sets an address mask for the CEP discovery group.
ipv4 mask |
unknown
Specifies an IPv4 address mask or an address mask of an
unknown IP protocol type.
Matrix>set cep detection 1 address ipv4 10.1.1.3
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
To Next Page
Loading...