Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-1
13
Routing Protocol Configuration
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1. Configuring RIP (Section 13.1.1)
2. Configuring OSPF (Section 13.1.2)
3. Configuring DVMRP (Section 13.1.3)
4. Configuring IRDP (Section 13.1.4)
5. Configuring VRRP (Section 13.1.5)
ROUTER: The commands covered in this chapter can be executed when the device is
in router mode only. For details on how to enable router configuration modes, refer to
Section 3.3.3.
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
To Next Page
Loading...