Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-16 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to map FID 3 to SID 2. This effectively maps VLAN 3 to Spanning Tree 2:
6.2.1.11 clear spantree mstmap
Use this command to map a FID back to SID 0.
clear spantree mstmap [fid_num]
Syntax Description
Command Defaults
If fid_num is not specified, all SID to FID mappings will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to map FID 2 back to SID 0:
6.2.1.12 show spantree vlanlist
Use this command to display the VLAN(s) mapped to a Spanning Tree ID.
show spantree vlanlist sid
Matrix>set spantree mstmap 3 2
fid_num (Optional) Resets the mapping of a specific FID. Valid
values are 1 - 4094, and must correspond to a VLAN ID
created using the set vlan command as described in
Section 7.3.2.1.
Matrix>clear spantree mstmap 2
To Next Page
Loading...