Port Priority and Classification Configuration Commands
Configuring Quality of Service (QoS)
9-12 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display the current algorithm, and queue 1 through 4 weights
configured on Fast Ethernet front panel ports 10 through 13:
9.3.3.2 set port qos sp
Use this command to enable 802.1p strict priority traffic queueing on one or more ports.
set port qos sp [port-string]
Syntax Description
Command Defaults
If port-string is not specified, all ports will be enabled for strict 802.1 queuing.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set strict queues on the front panel Fast Ethernet port 13. With this
configuration, all frames in the next higher queue must always be processed first:
Matrix>show port qos fe.0.10-13
Queue Queue 0 Queue 1 Queue 2 Queue 3
Port Algorithm Weight Weight Weight Weight
-------- --------- -------- -------- -------- --------
fe.0.10 WRR 25% 25% 25% 25%
fe.0.11 Hybrid 25% 30% 45% SP
fe.0.12 Hybrid 40% 60% SP SP
fe.0.13 Strict SP SP SP SP
port-string (Optional) Specifies the port(s) to enable as strict 802.1
queueing ports. For a detailed description of possible
port-string values, refer to Section 4.1.2.
Matrix>set port qos sp fe.0.13
To Next Page
Loading...
Need help?
General