Enterasys 1G58x-09 - Clear Logging Application; Show Logging Audit-Trail

Logging and Network Management Command Set
Configuring System Logging
11-20 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.1.13clear logging application
Use this command to reset the logging severity level for one or all applications to the default value
of 5 (warning conditions).
clear logging application {mnemonic | all}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the logging severity level for SSH:
11.2.1.14show logging audit-trail
Use this command to display the contents of a logging audit trail file. This will be a record of all
events that occur when users request and use specific system resources. The device can store up to
200 messages.
show logging audit-trail [file]
Syntax Description
mnemonic Resets the severity level for a specific application. Valid
mnemonic values and their corresponding applications are
listed in Table 11-3.
all Resets the severity level for all applications.
Matrix>clear logging application SSH
file (Optional) Displays a specific audit-trail log file.