Logging and Network Management Command Set
Configuring System Logging
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-11
Command Mode
Read-Write.
Example
This command shows how to enable a Syslog server configuration for index 1, IP address
134.141.89.113, facility local4, severity level 8 (debugging) port 514:
11.2.1.7 clear logging server
Use this command to remove a server from the Syslog server table.
clear logging server index
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to remove the Syslog server with index 1 from the server table:
11.2.1.8 show logging default
Use this command to display the Syslog server default values.
show logging default
Matrix>set logging server 1 ip_addr 134.141.89.113 facility local4 severity 8
port 514 state enable
index Specifies the server table index number for the server to
be removed. Valid values are 1 - 8.
Matrix>clear logging server 1
To Next Page
Loading...