Enterasys 1G58x-09 - Clear Priority Classification

Port Priority and Classification Configuration Commands
Configuring Priority Classification
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-23
9.3.4.4 clear priority classification
Use this command to clear priority classification entries.
clear priority classification priority_value data_meaning data_value
[data_mask]
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 9-1.
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and higher)
clear policy class (Section 8.3.2.4)
Example
This example shows how to remove the Ethernet II Type IP classification rule from port priority 7:
priority_value Specifies a port priority (0 through 7) associated with the
classification to be cleared.
data_meaning Specifies the data_meaning of the classification to be
cleared. Refer to Table 9-1 for the list of data_meaning
numbers and associated protocol types and
classifications.
data _value Specifies the data_value of the classification to be
cleared. The range of values is dependent on the
data_meaning. Refer to Table 9-1 for the limitations.
data_mask (Optional for most data values) Specifies a value
dependent on the data_value entered. For details, refer to
Table 9-1.
Matrix>clear priority classification 7 ethernet-II-type IP