Logging and Network Management Command Set
Monitoring Switch Network Events and Status
11-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
show users
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to use the show users command. In this output, there is one Telnet user
at IP address 10.1.10.10:
Matrix>show users
Console Port
------------
Active
Number of telnet users: 1
Telnet Session Users
--------------------
10.1.10.10
To Next Page
Loading...