Security Configuration Command Set
Configuring 802.1X Authentication
14-22 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v3.xx.xx and higher)
• set eapol auth-mode (Section 14.3.2.8)
Command Defaults
None.
Examples
This example shows how to set EAPOL port control to forced authorized mode on ports fe.0.1-5,
which disables authentication on these ports:
This example shows how to enable reauthentication control on Fast Ethernet front panel ports 1-3:
This example shows how to set the 802.1X quiet period to 120 seconds on Fast Ethernet front panel
ports 1-3:
supptimeout
timeout
Specifies a timeout period (in seconds) for the
authentication supplicant. Valid values are 1 -
2147483647.
txperiod value Specifies the period (in seconds) allowed for the
transmission of 802.1X keys. Valid values are 1 -
2147483647.
port-string Specifies the port(s) on which to configure authentication
settings. For a detailed description of possible port-string
values, refer to Section 4.1.2.
Matrix>set dot1x auth-config authcontrolled-portcontrol forced-auth fe.0.1.5
Matrix>set dot1x auth-config reathenabled true fe.0.1-3
Matrix>set dot1x auth-config quietperiod 120 fe.0.1-3
To Next Page
Loading...