Logging and Network Management Command Set
Configuring System Logging
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-9
show logging server [index]
Syntax Description
Command Defaults
If index is not specified, all Syslog server information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This command shows how to display Syslog server configuration information. For an explanation
of the command output, refer back to Table 11-1.
index (Optional) Displays Syslog information pertaining to a
specific server table entry. Valid values are 1-8.
Matrix>show logging server
IP Address Facility Severity Port Status
-------------------------------------------------------------------------
1 10.1.10.111 local7 warnings(5) 514 active
1 Desc:default
To Next Page
Loading...