General Configuration Command Set
Setting Basic Device Properties
3-46 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
If an offset is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how set daylight savings time to recur with a start date of April 4, 2004 at 2
a.m. and an ending date of October 31, 2004 at 2 a.m. with an offset time of one hour:
start_week Specifies the week of the month to start daylight savings
time. Valid values are: first, second, third, fourth, and
last.
start_day Specifies the day of the week to start daylight savings
time.
start_hr_min Specifies the time of day to start daylight savings time.
Format is hh:mm.
end_week Specifies the week of the month to end daylight savings
time.
end_day Specifies the day of the week to end daylight savings
time.
end_hr_min Specifies the time of day to end daylight savings time.
Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to
offset daylight savings time from the non-daylight
savings time system setting. Valid values are 1 - 1440.
Matrix>set summertime recurring first Sunday April 02:00 last Sunday October
02:00 60
To Next Page
Loading...