VLAN Configuration Command Set
Reviewing Existing VLANs
7-4 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
• If detail is not specified, summary information will be displayed.
• If vlan-list or vlan-name are not specified, information for all VLANs will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display information for all VLANs. In this case, there is only one
VLAN, the default VLAN 1. This display shows that VLAN 1 is the default VLAN and it is enabled
to operate. There are 48 Fast Ethernet ports in its port egress list, which are configured to transmit
untagged frames. There are no VLAN 1 forbidden ports:
This example shows how to display the information for VLAN 7 only. In this case, VLAN 7 has a
VLAN name of green and it is enabled. Fast Ethernet front panel ports 5 through 10, 12, and 30 are
detail (Optional) Displays detailed attributes of one or more
VLANs.
vlan-list |
vlan-name
(Optional) Displays information for specific VLAN(s). For
VLAN name to display, it must first be set using the set
vlan name command. For details, refer to Section 7.3.2.2.
Matrix>show vlan
VLAN: 1 Name: DEFAULT Status: enabled
Egress Ports
fe.0.1-48
Forbidden Egress Ports
None
Untagged Ports
fe.0.1-48
To Next Page
Loading...
Need help?
General