Enterasys 1G58x-09 User Manual

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-73
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display Cisco Discovery Protocol information. In this case, defaults
have not been changed:
Table 3-7 provides an explanation of the command output.
Matrix>show ciscodp
CiscoDP : Disabled
Timer : 60
Holdtime (TTL) : 180
Platform : Matrix 1G587-09
Version : 03.02.00
Device ID : 0123456789
PopulateCDP : Disabled
Table 3-7 show ciscodp Output Details
Output What It Displays...
CiscoDP Whether Cisco Discovery Protocol is disabled or enabled.
Default setting of disabled can be changed with the set
ciscodp status command as described in Section 3.2.6.5.
Timer Number of seconds between Cisco Discovery Protocol PDU
transmissions. Default value of 60 can be changed with the
set ciscodp timer command as described in Section 3.2.6.6.
Holdtime (TTL) Number of seconds neighboring devices will hold PDU
transmissions from the sending device. Default value of 180
can be changed with the set ciscodp holdtime command as
described in Section 3.2.6.7.
Platform Description of the sending device.
Version Sending device’s firmware version.

Enterasys 1G58x-09 Specifications

General

Brand	Enterasys
Model	1G58x-09
Category	Network Hardware
Language	English