VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
7-26 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
set vlan classification vlan-id data_meaning data_value [data_mask] {create |
enable | disable}
Syntax Description
vlan-id Specifies the number of the VLAN on which to apply the
classification rule. Valid values and associated actions
are:
• 4095: permits these frames to forward on all VLANs.
• 0: denies and discards these frames for all VLANs.
• 1: classifies these frames the default VLAN.
• 2 - 4094: classifies these frames to the specified
VLAN.
data_meaning Specifies the parameter used to classify or filter frames.
Refer to Table 7-1 and Table 7-2 for lists of supported
data_meanings and associated protocol types and
classifications.
data_value Specifies the code for a predefined classifier. This value is
dependent on the classification entered, as stated in
Table 7-1 and Table 7-2. This information must be
entered for each classifier associated with that protocol.
data_mask (Not required for most data values.) Specifies a value
dependent on the data_value entered. For details, refer to
Table 7-2.
To Next Page
Loading...