Port Priority and Classification Configuration Commands
Configuring Priority Classification
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-25
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 9-1.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set a ToS value of 200 to frames with a priority 7, meeting the Ethernet
Type II IP classification rule:
tos_value Specifies an integer (0 - 255) to identify priority to the
various switch devices and routers in the IP-based
network.
priority_value Specifies a port priority (0 through 7) associated with the
classification to be set.
data_meaning Specifies the data_meaning for the parameter used to
classify frames. Refer to Table 9-1 for the list of the
data_meanings and associated protocol types and
classifications.
data _value Specifies the code of a predefined classifier. The range of
values is dependent on the data_meaning. Refer to
Table 9-1 for the limitations.
data_mask (Not required for most data values) Specifies a value
dependent on the data_value entered. For details, refer to
Table 9-1.
Matrix>set priority classification tosvalue 200 7 ethernet-II-type IP
To Next Page
Loading...