IP Configuration Command Set
Configuring Routing Interface Settings
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-5
Example
This example shows how to display information for all interfaces configured on the router:
Matrix>Router#show interface
Vlan 1 is Administratively UP
Vlan 1 is Operationally UP
Internet Address is 10.1.1.1, Subnet Mask is 255.0.0.0
Internet Address is 11.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 12.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 13.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 14.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 15.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 16.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 17.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Internet Address is 18.1.1.1, Subnet Mask is 255.0.0.0 Secondary
Mac Address is: 0001.f4c1.6b1f
The name of this device is Vlan 1
Ports in Vlan: fe.0.1-46,fe.1.1-16, ge.2.1-2, ge.3.1-2
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
Vlan 47 is Administratively UP
Vlan 47 is Operationally DOWN
Internet Address is 47.1.1.1, Subnet Mask is 255.0.0.0
Mac Address is: 0001.f4c1.6b1f
The name of this device is Vlan 47
Ports in Vlan: fe.0.47
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
To Next Page
Loading...
Need help?
General