IP Configuration Command Set
Configuring Broadcast Settings
12-26 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to permit UDP broadcasts from hosts on networks 191.168.1.255 and
192.24.1.255 to reach servers on those networks:
Matrix>Router(config)#ip forward-protocol udp
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip helper-address 192.168.1.255
Matrix>Router(config)#interface vlan 2
Matrix>Router(config-if(Vlan 2))#ip helper-address 192.24.1.255
To Next Page
Loading...