IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-30 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
If softpath is not specified, general IP traffic statistics will be displayed.
Example
This example shows how to display IP traffic statistics:
Matrix>Router#show ip traffic
IP Statistics:
Rcvd: 10 total, 6 local destination 0 header errors
0 unknown protocol, 0 security failures
Frags: 0 reassembled, 0 timeouts 0 couldn't reassemble
0 fragmented, 0 couldn't fragment
Bcast: 1 received, 8 sent
Mcast: 0 received, 16 sent
Sent: 24 generated, 0 forwarded
0 no route
ICMP Statistics:
Rcvd: 4 total, 0 checksum errors, 0 redirects, 0 unreachable, 4 echo
0 echo reply, 0 mask requests, 0 quench
0 parameter, 0 timestamp, 0 time exceeded,
Sent: 6 total, 0 redirects, 0 unreachable, 0 echo, 4 echo reply
0 mask requests, 2 mask replies, 0 quench, 0 timestamp
0 info reply, 0 time exceeded, 0 parameter problem
UDP Statistics:
Rcvd: 1 total, 0 checksum errors, 1 no port
Sent: 6 total, 0 forwarded broadcasts
TCP Statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total
IGMP Statistics:
Rcvd: Messages 1 Errors 0
Reports 1 Queries 0
Leaves 0 Unknowntype 0
Sent: OutMessages 2
ARP Statistics:
Rcvd: 1 requests, 0 replies, 0 others
Sent: 0 requests, 1 replies
To Next Page
Loading...