IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router#
Command Defaults
If no parameters are specified, all IP route information will be displayed.
Example
This example shows how to display all IP route information. In this case, there are two IP routes
and each one is directly connected to a VLAN:
destination prefix
destination prefix
mask
longer-prefixes
(Optional) Converts the specified address and mask into a
prefix and displays any routes that match the prefix.
connected (Optional) Displays connected routes.
ospf (Optional) Displays routes configured for the OSPF routing
protocol.
rip (Optional) Displays routes configured for the RIP routing
protocol.
static (Optional) Displays static routes.
summary (Optional) Displays a summary of the IP routing table.
Matrix>Router#show ip route
Codes: C-connected, S-static, R-RIP, B-BGP, O-OSPF, IA-OSPF interarea
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - 0SPF external type 1, E2 - 0SPF external type 2
E - EGP, i - IS-IS, L1 - IS-IS level-1, LS - IS-IS level-2
* - candidate default, U - per-user static route, o - ODR
Gateway of last resort is not set
C 182.127.63.0/24
[0001] directly connected, Vlan 1
C 182.127.62.0/24
[0001] directly connected, Vlan 2
To Next Page
Loading...
Need help?
General