Process Overview: Routing Protocol Configuration
Configuring RIP
13-16 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the send-lifetime configuration for an
authentication key. Start time can be specified, but is not mandatory:
no send-lifetime [start-time month date year]
Command Type
Router command.
Command Mode
Key chain key configuration: Matrix>Router(config-keychain-key)#
Command Defaults
None.
start-time Specifies the time of day the authentication key will begin to
be valid to be sent. Valid input is hours:minutes:seconds
(hh:mm:ss)
month Specifies the month the authentication key will begin to be
valid to be sent. Valid input is the first three letters of the
month.
date Specifies the day of the month the authentication key will
begin to be valid to be sent. Valid values, depending on the
length of the month, are 1 - 31.
year Specifies the year the authentication key will begin to be
valid to be sent. Valid input is four digits up to 2035.
duration seconds Length of time (in seconds) the key is valid to be sent. Valid
values are 1 - 4294967295.
end-time Specifies the hours, minutes and seconds (hh:mm:ss) and
the month, date and year from the start-time the key is valid
to be sent.
infinite Specifies that the key is valid to be sent from the start-time
on.
To Next Page
Loading...
Need help?
General