Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-59
Syntax Description
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router#
Command Defaults
• If detail is not specified, summary information will be displayed.
• If ip_address is not specified, OSPF neighbors will be displayed for all IP
addresses configured for routing.
• If vlan_id is not specified, OSPF neighbors will be displayed for all VLANs
configured for routing.
Example
This example shows how to use the show ospf neighbor command:
Table 13-5 provides an explanation of the command output.
detail (Optional) Displays detailed information about the
neighbors, including the area in which they are neighbors,
who the designated router/backup designated router is on the
subnet, if applicable, and the decimal equivalent of the E-bit
value from the hello packet options field.
ip_address (Optional) Displays OSPF neighbors for a specific IP
address.
vlan vlan_id (Optional) Displays OSPF neighbors for a specific VLAN.
This VLAN must be configured for IP routing as described
in Section 3.3.2.
Matrix>Router#show ip ospf neighbor
ID Pri State Dead-Int Address Interface
182.127.62.1 1 FULL 40 182.127.63.1 vlan1
To Next Page
Loading...
Need help?
General