Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-65
Example
This example shows how to display PWA information:
Table 14-7 provides an explanation of the command output.
Matrix>show pwa
PWA Status - disabled
PWA Hostname - secureharbour
PWA IP Address - 0.0.0.0
PWA Name Services - disabled
PWA Protocol - PAP
PWA Enhanced Mode - disabled
PWA Logo - displayed
PWA Guest Name - guest
PWA Guest Password -
PWA Guest Network Status - disabled
PWA Refresh Time - 30
Port Mode Auth Status QuietPeriod MaxReq
------- ---------------- -------------- ----------- -------
ge.0.1 forceAuthorized authenticated 60 2
ge.0.2 forceAuthorized authenticated 60 2
ge.0.3 forceAuthorized authenticated 60 2
ge.0.4 forceAuthorized authenticated 60 2
ge.0.5 forceAuthorized authenticated 60 2
ge.0.6 forceAuthorized authenticated 60 2
Table 14-7 show pwa Output Details
Output What It Displays...
PWA Status Whether or not port web authentication is enabled or
disabled. Default state of disabled can be changed using the
set pwa command as described in Section 14.3.5.2.
PWA Hostname Host name (URL) for accessing the Secure Harbour login /
logoff web page. Default of secureharbour can be changed
using the set pwa hostname command as described in
Section 14.3.5.3.
PWA IP Address IP address of the end station from which PWA will prevent
network access until the user is authenticated. Set using the
set pwa ipaddress command as described in
Section 14.3.5.7.
To Next Page
Loading...
Need help?
General