Contents
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide vii
3.2.3 Downloading a Firmware Image ................................................... 3-50
3.2.3.1 Downloading via the Serial Port ................................ 3-50
3.2.3.2 Downloading via TFTP .............................................. 3-51
3.2.4 Configuring Telnet......................................................................... 3-54
3.2.4.1 show telnet ................................................................ 3-54
3.2.4.2 set telnet .................................................................... 3-55
3.2.5 Managing Switch Configuration Files............................................ 3-57
3.2.5.1 dir............................................................................... 3-57
3.2.5.2 show config................................................................ 3-58
3.2.5.3 configure.................................................................... 3-60
3.2.5.4 summaryconfig .......................................................... 3-62
3.2.5.5 copy ........................................................................... 3-64
3.2.5.6 set system bootconfig................................................ 3-66
3.2.5.7 delete......................................................................... 3-67
3.2.6 Configuring Enterasys and Cisco Discovery Protocols................. 3-68
3.2.6.1 show cdp ................................................................... 3-69
3.2.6.2 set cdp ....................................................................... 3-70
3.2.6.3 set cdp interval .......................................................... 3-72
3.2.6.4 show ciscodp ............................................................. 3-72
3.2.6.5 set ciscodp status ...................................................... 3-74
3.2.6.6 set ciscodp timer........................................................ 3-74
3.2.6.7 set ciscodp holdtime .................................................. 3-75
3.2.6.8 set ciscodp populatecdp ............................................ 3-76
3.2.6.9 show port ciscodp info ............................................... 3-76
3.2.6.10 show port ciscodp neighborinfo ................................. 3-78
3.2.6.11 set port ciscodp status............................................... 3-79
3.2.6.12 set port ciscodp trust-ext ........................................... 3-80
3.2.6.13 set port ciscodp cos-ext............................................. 3-81
3.2.6.14 set port ciscodp vvid .................................................. 3-82
3.2.7 Pausing, Clearing and Closing the CLI ......................................... 3-84
3.2.7.1 wait ............................................................................ 3-84
3.2.7.2 cls (clear screen) ....................................................... 3-85
3.2.7.3 exit ............................................................................. 3-85
3.2.8 Resetting the Device..................................................................... 3-87
3.2.8.1 show reset ................................................................. 3-87
3.2.8.2 reset........................................................................... 3-88
3.2.8.3 reset at....................................................................... 3-89
3.2.8.4 reset in....................................................................... 3-90
3.2.8.5 clear config ................................................................ 3-90
3.3 Preparing the Device for Router Mode.......................................................... 3-92
3.3.1 Pre-Routing Configuration Tasks.................................................. 3-92
3.3.2 Configuring VLANs for IP Routing ................................................ 3-93
3.3.3 Enabling Router Configuration Modes .......................................... 3-96
To Next Page
Loading...