1-20
Description
Use the boot web-package command to configure a Web file in the fabric to be with the main or backup
attribute.
z Before configuring the main or backup attribute for a Web file in the fabric, make sure the file exists
on all devices in the fabric.
z The configuration of the main or backup attribute for a Web file takes effect immediately without
restarting the device.
z After you upgrade a Web file, you need to specify the new Web file in the Bootrom menu after
restarting the switch or specify a new Web file by using the boot web-package command.
Otherwise, the Web server cannot function normally.
Related commands: display web package
Examples
# Configure the Web file named boot.web to be with the main attribute.
<Sysname> boot web-package boot.web main
display boot-loader
Syntax
display boot-loader [ unit unit-id ]
View
Any view
Parameters
unit unit-id: Specifies the unit ID of a switch. The APP startup file information of the specified unit will be
displayed.
Description
Use the display boot-loader command to display the information about the APP startup files of the
fabric or of a specific device in the fabric. Displayed information includes the current APP startup file
name, and the main and backup APP startup files to be used when the switch starts up next time.
If you execute the display boot-loader command without unit unit-id, the information of all app startup
files of the fabric will be displayed.
Examples
# Display information about the app startup files of unit 1.
<Sysname> display boot-loader unit 1
Unit 1
The current boot app is: test.bin
To Next Page
Loading...
Need help?
General