1-1
1 PoE Configuration Commands
The newly added function is upgrading the PoE module of the fabric switch remotely. See update fabric
for details.
PoE Configuration Commands
display poe interface
Syntax
display poe interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Port type and port number.
Description
Use the display poe interface command to view the PoE status of a specific port or all ports of the
switch.
If the interface-type interface-number argument is not specified, the command displays the PoE status
of all ports of the switch.
Related commands: poe enable, poe max-power, poe mode, poe power-management, poe
priority.
Examples
# Display the PoE status of Ethernet 1/0/10.
<Sysname> display poe interface Ethernet1/0/10
Port power enabled :enable
Port power ON/OFF :on
Port power status :Standard PD was detected
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :15400 mW
Port current power :460 mW
To Next Page
Loading...
Need help?
General