H3C S3600 Series Command Manual

1-2
# Display NDP information about Ethernet 1/0/1.
<aaa_0.Sysname> display ndp interface Ethernet 1/0/1
Interface: Ethernet1/0/1
Status: Enabled, Pkts Snd: 15835, Pkts Rvd: 2879, Pkts Err: 0
Neighbor 1: Aging Time: 147(s)
MAC Address : 000f-e20f-1234
Port Name : Ethernet1/0/1
Software Ver: V100R002B01D001
Device Name : Sysname S3600-28TP-SI
Port Duplex : AUTO
Product Ver : 3600-0001
Table 1-1 Description on the fields of the two commands
Field Description
Neighbor Discovery Protocol is enabled NDP is enabled globally on the switch.
Neighbor Discovery Protocol Ver: 1 NDP version 1 is running.
Hello Timer
Interval for the switch to send NDP packets,
which is configured through the ndp timer hello
command
Aging Timer
Holdtime for neighbors to keep the NDP
information of the switch, which is configured
through the ndp timer aging command
Interface Port index, used to identify a port
Status NDP state on the port (enabled/disabled)
Pkts Snd: Number of NDP packets sent by the port
Pkts Rvd: Number of NDP packets received by the port
Pkts Err:
Number of error NDP packets received by the
port
Neighbor 1: Aging Time
Holdtime for this switch to keep the NDP
information of the neighbor connected to the port
MAC Address MAC address of the neighbor device
Port name Port name of the neighbor device
Software Ver Software version of the neighbor device
Device Name Device name of the neighbor device
Port Duplex
Port (full/half) duplex mode of the neighbor
device
Product Ver Product version of the neighbor device
ndp enable
Syntax
ndp enable [ interface interface-list ]
undo ndp enable [ interface interface-list ]

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English