5-4
Table 5-2 Description on the fields of the display route-policy command
Field Description
Route-policy Name of a routing policy
Information about the routing policy with the matching mode configured as permit
and the node as 10.
if-match (ip-prefix) p1 Matching conditions
Permit 10
apply cost 100
Apply the cost 100 to the routes satisfying the
matching conditions.
if-match { acl | ip-prefix }
Syntax
if-match { acl acl-number | ip-prefix ip-prefix-name }
undo if-match { acl | ip-prefix }
View
Route policy view
Parameters
acl-number: Number of the ACL used for filtering, in the range of 2000 to 3999.
ip-prefix-name: Name of the IP prefix list used for filtering, a string of up to 19 characters.
Description
Use the if-match command to match routes permitted by an ACL or IP prefix list.
Use the undo if-match command to remove the configuration.
By default, the if-match clause is not configured.
Related commands: if-match interface, if-match ip next-hop, if-match cost, if-match tag,
route-policy, apply cost, apply tag.
Examples
# Define an if-match clause to match routing information permitted by IP-prefix p1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] route-policy policy permit node 1
%New sequence of this list
[Sysname-route-policy] if-match ip-prefix p1
if-match cost
Syntax
if-match cost value
undo if-match cost
To Next Page
Loading...
Need help?
General