1-40
Parameters
ip-address: IP address of the primary authentication/authorization server to be used, in dotted decimal
notation.
port-number: UDP port number of the primary authentication/authorization server, ranging from 1 to
65535.
Description
Use the primary authentication command to set the IP address and port number of the primary
RADIUS authentication/authorization server used by the current RADIUS scheme.
Use the undo primary authentication command to restore the default IP address and port number of
the primary RADIUS authentication/authorization server, which are 0.0.0.0 and 1812 respectively.
In the system default RADIUS scheme “system”, the default IP address of the primary
authentication/authorization server is 127.0.0.1 and the default UDP port number is 1645. In a new
RADIUS scheme, the default IP address of the primary authentication/authorization server is 0.0.0.0
and the default UDP port number is 1812.
Note that:
z After creating a new RADIUS scheme, you should configure the IP address and UDP port number
of each RADIUS server you want to use in this scheme. These RADIUS servers fall into two types:
authentication/authorization, and accounting. For each kind of server, you can configure two
servers in a RADIUS scheme: primary and secondary servers.
z In an actual network environment, you can make RADIUS server-related configuration as required.
But you should configure at least one authentication/authorization server and one accounting
server, and at the same time, you should keep the RADIUS server port settings on the switch
consistent with those on the RADIUS servers.
Related commands: key, radius scheme, state.
Examples
# Set the IP address and UDP port number of the primary authentication/authorization server for
RADIUS scheme radius1 to 10.110.1.1 and 1812 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] primary authentication 10.110.1.1 1812
radius client
Syntax
radius client enable
undo radius client
View
System view
To Next Page
Loading...
Need help?
General