1-1
1 Information Center Configuration Commands
The information center now supports to add the UTC time zone in the time stamp of the output
information. See
info-center timestamp utc for details.
Information Center Configuration Commands
display channel
Syntax
display channel [ channel-number | channel-name ]
View
Any view
Parameters
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10 channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in turn) console,
monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
Description
Use the display channel command to display the settings of an information channel.
If no argument is specified in the command, the settings of all channels are displayed.
Examples
# Display the settings of information channel 0.
<Sysname> display channel 0
channel number:0, channel name:console
MODU_ID NAME ENABLE LOG_LEVEL ENABLE TRAP_LEVEL ENABLE DEBUG_LEVEL
ffff0000 default Y warning Y debugging Y debugging
display info-center
Syntax
display info-center [ unit unit-id ]
To Next Page
Loading...
Need help?
General