1-20
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1]
jumboframe enable
Syntax
jumboframe enable
undo jumboframe enable
View
Ethernet port view
Parameters
None
Description
Use the jumboframe enable command to set the maximum frame size allowed on a port to 9,216
bytes.
Use the undo jumboframe enable command to set the maximum frame size allowed on a port to 1,536
bytes.
By default, the maximum frame size allowed on an Ethernet port is 9,216 bytes.
Examples
# Set the maximum frame size allowed on Ethernet 1/0/1 to 1,536 bytes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] jumboframe enable
link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet port view
Parameters
delay-time: Port state change delay to be set. This argument is in the range 2 to 10 (in seconds).
Description
Use the link-delay command to set the port state change delay.
Use the undo link-delay command to restore the default.
By default, the port state change delay is 0 seconds, that is, the port state changes without any delay.
To Next Page
Loading...
Need help?
General