1-2
Table 1-1 Description on the fields of the display link-aggregation interface command
Field Description
Selected AggID
ID of the aggregation group to which the
specified port belongs
Local Information about the local end
Port-Priority Port priority
Oper key Operation key
Flag Protocol status flag
Remote Information about the remote end
System ID Remote device ID
Port number Port number
Received LACP Packets: 0 packet(s), Illegal: 0
packet(s)
Sent LACP Packets: 0 packet(s)
Statistics about received, invalid, and sent LACP
packets
display link-aggregation summary
Syntax
display link-aggregation summary
View
Any view
Parameters
None
Description
Use the display link-aggregation summary command to display summary information of all
aggregation groups.
Note that as ports in a manual link aggregation groups do not acquire the information about their peers
automatically, so the entries in the information about the peer ports displayed are all 0 instead of the
actual values.
Examples
# Display summary information of all aggregation groups.
<Sysname> display link-aggregation summary
Aggregation Group Type:D -- Dynamic, S -- Static , M -- Manual
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor ID: 0x8000, 000f-e20f-5104
AL AL Partner ID Select Unselect Share Master
ID Type Ports Ports Type Port
To Next Page
Loading...
Need help?
General