1-3
Table 1-2 Description on the fields of the display vrrp verbose command
Field Description
Run Method
Current VRRP running method, including REAL-MAC and
VIRTUAL-MAC
Virtual Ip Ping Whether you can ping the virtual IP address of the VRRP group
Interface Interface where the VRRP group resides
VRID VRRP group ID
Adver. Timer Interval for sending VRRP advertisements
Admin Status Administrative state: UP or DOWN
State
Status of the current switch in the VRRP group, including Master,
Backup and Initialize
Config Pri Configured priority
Run Pri Running priority
Preempt Mode Preemptive mode
Delay Time Preemption delay
Auth Type Authentication type, including NONE, SIMPLE, and MD5
Virtual IP Virtual IP address of the VRRP group
Virtual MAC
Virtual MAC address corresponding to the virtual IP address of the
VRRP group. It is displayed only when the switch is in the state of
master.
Master IP
Primary IP address of the master’s interface where the VRRP group
is configured.
display vrrp statistics
Syntax
display vrrp statistics [ interface vlan-interface vlan-id [ vrid virtual-router-id ] ]
View
Any view
Parameters
vlan-interface vlan-id: Specifies a VLAN interface by its VLAN ID. vlan-id is the ID of the VLAN
interface.
vrid virtual-router-id: Specifies a VRRP group. virtual-router-id is the VRRP group ID, ranging from 1 to
255.
Description
Use the display vrrp statistics command to display the VRRP statistics information of VRRP group(s).
Refer to
Table 1-3 for the displayed information.
z If neither a VLAN interface nor a VRRP group is specified, the statistics information about all the
VRRP groups on the switch is displayed.
To Next Page
Loading...
Need help?
General