1-2
z If you specify a VLAN interface only, the command will display the state information of all VRRP
groups on the specified VLAN interface.
z If you specify both a VLAN interface and a VRRP group, the command will display the state
information of the specified VRRP group on the specified VLAN interface.
Examples
# Display the VRRP state information about all the VRRP groups on the switch.
<Sysname> display vrrp
Run Method : VIRTUAL-MAC
Virtual Ip Ping : Disable
The total number of the virtual routers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
--------------------------------------------------------------------------
Vlan2 2 Initialize 100 1 NONE 173.160.0.1
Table 1-1 Description on the fields of the display vrrp command
Field Description
Run Method
Current VRRP running method, including REAL-MAC and
VIRTUAL-MAC
Virtual IP ping Whether you can ping the virtual IP address of the VRRP group
Interface Interface where the VRRP group resides
VRID ID of the virtual router
State
Status of the current switch in the VRRP group, including Master,
Backup and Initialize
Run Pri Running priority
Adver. Timer Interval for sending VRRP advertisements
Auth Type Authentication type, including NONE, SIMPLE, and MD5
Virtual IP Virtual IP address of the VRRP group
# Display detailed information about all VRRP groups on the switch.
<Sysname> display vrrp verbose
Run Method : VIRTUAL-MAC
Virtual Ip Ping : Disable
Interface : Vlan-interface1
VRID : 1 Adver. Timer : 1
Admin Status : UP State : Master
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : 192.168.0.133
Virtual MAC : 0000-5e00-0101
Master IP : 192.168.0.68
To Next Page
Loading...
Need help?
General