1-12
[Sysname] ntp-service reliable authentication-keyid 37
ntp-service source-interface
Syntax
ntp-service source-interface Vlan-interface vlan-id
undo ntp-service source-interface
View
System view
Parameters
vlan-interface vlan-id: Specifies an interface. The IP address of the interface serves as the source IP
address of sent NTP packets. The vlan-id argument indicates the ID of the specified VLAN interface.
Description
Use the ntp-service source-interface command to specify a VLAN interface through which NTP
packets are to be sent.
Use the undo ntp-service source-interface command to remove the configuration.
If you do not want the IP addresses of the other interfaces on the local switch to be the destination
addresses of response packets, you can use this command to specify a specific interface to send all
NTP packets. In this way, the IP address of the interface is the source IP address of all NTP packets
sent by the local device.
Examples
# Specify the source IP addresses of all sent NTP packets as the IP address of VLAN-interface 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ntp-service source-interface Vlan-interface 1
ntp-service unicast-peer
Syntax
ntp-service unicast-peer { remote-ip | peer-name } [ authentication-keyid key-id | priority |
source-interface Vlan-interface vlan-id | version number ]*
undo ntp-service unicast-peer { remote-ip | peer-name }
To Next Page
Loading...
Need help?
General