1-24
verbose
Syntax
verbose
undo verbose
View
FTP client view
Parameters
None
Description
Use the verbose command to enable the verbose function, which displays execution information of
user operations and all FTP responses.
Use the undo verbose command to disable the verbose function.
The verbose function is enabled by default.
Examples
# Download the file with name test1.cfg.
[ftp] get test1.cfg
227 Entering Passive Mode (192,168,0,3,5,239)
150 "D:\FTP\test1.cfg" file ready to send (100 bytes) in ASCII mode
....226 Transfer finished successfully.
FTP: 100 byte(s) received in 5.109 second(s) 20.00 byte(s)/sec.
# Disable the verbose function.
[ftp] undo verbose
# Download the file with name test.cfg.
[ftp] get test.cfg
......FTP: 1740 byte(s) received in 9.367 second(s) 185.00 byte(s)/sec.
The above output indicates that if the verbose function is disabled, only execution information of users’
operations is obtained from the system of the switch, while the output information beginning with
three-digit numbers cannot be returned to the users.
For the description of the numbers at the beginning of FTP output information, refer to the
corresponding section in RFC 959.
SFTP Server Configuration Commands
sftp server enable
Syntax
sftp server enable
undo sftp server
To Next Page
Loading...
Need help?
General